Information:
- Level: Beginner
- Installation time: 2 min
Hardware required for installation:
- Hex key 1.5mm
Important:
Always wear protective eyewear when handling airsoft products.
1. To start, place your magazine on a stable surface.
2. Use a 2.5 mm hex key to fully unscrew the screw at the back of the base pad.
3. Remove the base pad, keeping in mind the resistance of the spring.
4. Remove the magazine spring.
5. Remove the follower button.
6. To remove the feed lips, use a 1.5 mm hex key to unscrew the two screws that hold them in place.
0 comments