Information :
- Fits Hi-capa and Glock models.
- Beginner level
- Installation time: 10-15 min
Materials required for installation :
- A gbb magazine (depending on the model chosen)
- PH2 screwdriver
- Silicone grease
Important :
- Always wear protective eyewear when handling airsoft products.
- Before beginning installation, remove the base pad, spring and push button from your GBB. Keep the magazine, the screw and the 2 gaskets (one on the screw and one on the base pad).
1. Gather your adapter and the included parts.
2. Insert the guide rod into your magazine.
Make sure the spacing of the rod allows the BBs to pass through smoothly.
If needed, gently spread each arm outward at the designated slot.
3. Place the provided "A" O-ring onto the notch at the top of the adapter, and apply a generous amount of silicone around it (the original O-ring from your magazine can also be used).
4. Place the provided "B" O-ring around the screw (the original O-ring can also be used).
5. Align the adapter with the magazine, then carefully insert it, applying pressure toward the back of the magazine.
6. To complete the installation, insert the screw into its designated slot and tighten firmly using a PH2 screwdriver or similar (the goal is to compress the O-ring as much as possible to create a perfect seal without damaging the screw head).
0 comments